I get a lot of questions about what glue to use on PaperTerrain models. Well, the answer to the question has changed a bit over time. When I first started PaperTerrain I used an inkjet printer to print out the models. Inkjet ink has the problem of being water soluble. If you get it wet, the ink will smear and run. So, in those days I recommended against water-based glue like PVA (white glue). PVA would work, but you had to be careful. I recommended non-water-based glues like the old Duco Cement or the Michael's Craft store equivalent Bond 527. Both are a clear, smelly glue that comes out of a tube. But then I changed over to a color laserjet printer. This greatly improved the quality of the output, but the toner was not water-soluble. So now if you want to use PVA, go right ahead. Ironically, I soon discovered that the Duco Cement or Bond 527 which I had been using dissolved the toner used by the laserjet! Exactly the reverse situation as before! Now frankly, I don't like PVA glue. It's messy and takes a long time to dry. So for a while I continued to used the Duco or Bond 527--I just had to be careful. But then I discovered a new glue called "UHU Twist-n-Glue". It is a clear glue that comes in a funny-shaped yellow bottle and is available from Michael's Crafts. It has the best of both worlds. It dries quickly and it does not dissolve the pigment. I like it a lot.
Best Glue?
(1 post) (1 voice)-
Posted 9 months ago #
Reply
You must log in to post.